Make your own free website on Tripod.com
Custom D-Rings for 12" lightsabers
  • Tools Needed
    • Dremel or other rotary tool
    • 2 pairs of pliers (one needle nose)
    • length of thick gauge wire
    • very thin sheet of tin or aluminum 
    • pair of tin snips or kitchen shears (regular scissors may work)
    • Small thin nail & a hammer
    • several pins
    • hair dryer or heat gun

     


    -- Helpful tips --

    When forming the D-ring it's easy to just find the width you want on the
    needle nose pliers then wrap the wire around the pliers at that point

    I used the lid to a can of cat food for my aluminum plate,
    you could also use the outside of a pop can